PCB preview top
PCB preview bottom
Stencil preview top
Stencil preview bottom

Readme

There is an instructable on how to build and use the board : https://www.instructables.com/id/ChipKIT-Getting-Used-to-It/

There is also a video showing how I soldered the board : https://www.youtube.com/watch?v=SHd6oalV9ac

Parts

Name Description
3x D8 / D7 / D9 LED GREEN CLEAR 1206 SMD
1x 24LC256 EEPROM Serial-I2C 32K-bit 4K x 8 1.8V/2.5V/3.3V/5V 8-Pin SOIC T/R
4x C2 / C3 / C4 / C8 Cap Ceramic 0.1uF 50V X7R 10% SMD 1206 125°C Embossed Plastic T/R
2x C6 / C7 Capacitor; Ceramic; Cap 33 pF; Tol 5%; Vol-Rtg 100 VDC; SMT; 1206; COG; Cut Tape
2x D11 / D12 1N5819HW Series 40 V 1 A Surface Mount Schottky Barrier Rectifier - SOD-123
1x D6 LED RED CLEAR 1206 SMD
1x CN2 MINI USB RA DIP
2x C5 / C1 CAP TANT 0.1UF 35V 20% 1206
2x PROG / S3 Switch Tactile OFF (ON) SPST Round Button Gull Wing 0.05A 12VDC 1.57N SMD T/R
1x PWR Conn Unshrouded Header HDR 2 POS 2.54mm Solder ST Thru-Hole Bag
3x R10 / R11 / R7 Res Thick Film 1206 220 Ohm 1% 0.25W(1/4W) ?100ppm/?C Molded SMD Paper Tape on Plastic Reel
4x R12 / R4 / R8 / R9 High Power Anti-Sulfur Thin Film Chip Resistor
2x R13 / R14 Res Thick Film 1206 4.7K Ohm 5% 1/4W ±200ppm/°C Molded SMD SMD Paper Tape on Plastic Reel
1x R5 RC Series 1206 0.25 W 470 Ohms 5% ±100 ppm/°C SMT Thick Film Chip Resistor
1x U$1 2.0 mm Center Pin, 2.5 A, Right Angle, Through Hole, Tapered Pins, Dc Power Jack Connector
1x X1117_3V3 AP1117 Series 3.3 V Fixed Output 1A Surface Mount LDO Regulator - SOT-223
1x Y1 Crystal 8MHz ±30ppm (Tol) ±50ppm (Stability) 18pF FUND 80Ohm 2-Pin HC-49/US SMD T/R
1x U1 IC MCU 32BIT 128KB FLASH 28SOIC
1x X1117_5V IC REG LINEAR POS ADJ 1A SOT223

Change organization, repository and project title

Whoops, we have to know where to deliver this project to!

  • Shipping address
    or add new
  • Billing address (optional)
    or add new

For your convenience we'll keep your settings to speed up the next checkout.